Lasercut Laptop Stand


This is the project page for the Lasercut Laptop Stand.

This project was designed in Adobe Illustrator and took roughly 3 hours to design. The stand is made out of 1/4" plywood and took about 10 minutes to cut out on an 60 Watt Epilog Mini Laser Cutter.

The stand is angled at approximately 45° but can be adjusted slightly due to the size of the wooden slots for the cross-section. The overall design allows for air to travel underneath the device and through the stand. Additionally, there is a hexagonal cooling ventilation pattern on the laptop resting plate as well as the cross-section for increased airflow. The entire stand folds down and stows at an impressive .5", perfect for a breifcase or backpack.

Quick Specs

  • Price: $10
  • Dimensions: 10.2 x 8.75 x .5 (stowed)
  • Total Pieces: 3
  • Material: 1/4" Plywood

If you'd like to purchase one for $10, please use the form on the Contact Page and set the subject to "Laptop Stand Order".


Click Here to go back to the Projects page.